Oiran JAPAN 46LED Truck Red & Clear for reverse

Description

Red/Clear when installed

Red/clear when lit

Red/clear turn signal, brake lights on

Red/clear turn signal, small when lit

Red/Clear Small when lit

Uses high quality LEDs

We use high quality LEDs with long lifespan and high brightness .

Heat compression bonding specifications

This product boasts extremely high quality because it is assembled using the same thermocompression method used to produce genuine domestic tail lamps.

size

The size of this product is as follows.

Width 185 mm x Height 210 mm x Depth 80 mm

Safety standard compliance

This product has been certified as a safety standard compliant product (E mark) .

What is a “safety standard compliant product (E mark)”?

A safety standard compliant product (E mark) is a certification based on global standards, and the safety standard compliant product (E mark) is engraved on the product itself. This is a global standard certification mark that is displayed on products that have obtained EC type certification, which certifies that they meet standards based on EU directives .
Even if they are repair parts such as after-sales parts made in Japan, the E mark is always displayed on parts sold all over the world.

*Depending on the number of installations, installation position, and installation method, the product may not pass vehicle inspection, so please check with the store/dealer where you purchased it or the installation factory.

Component part

The package contents of this product are as follows.

• Tail lamp body x 1 unit
• Fixing bracket bolt and nut set for body mounting
  • Bracket x 1
  • Nut x 2
  • Spring washer x 2
  • Flat washer x 2
• Tail lamp connection stainless steel bolt set *1
  • Bolt x 2
  • Nut x 2
  • Flat washer x 4
• Reflector for side mounting x 1

*1 Regarding the connection bolt set, one set is included for each unit or two units purchased at the same time.

When purchasing 2 units of this product at the same time

If you purchase only one unit of this product, the connecting harness (with high flash prevention/resistor) is not included.
If you purchase two units of this product at the same time, one connecting harness (with high flash prevention/resistor) will be included.
Please note that if you purchase two units of this product and install one on each side, a separate harness will be required.

Example of component attachments

Notes

Depending on the vehicle model, this product may have a burnout warning light on. In that case, you can cancel it by installing a 46LED dedicated 4-wire resistor (sold separately).