Oiran KAKU LED truck tail lamp – corner – (for reverse)

Description

When the back lamp is on

When small/position is lit

When the brake is on

When fully lit

A sophisticated design that is timeless

It uses advanced tube LEDs and high-brightness LEDs, and
when turned on, it emits an overwhelming sparkle, making it highly visible at night.

The exterior plated frame and carefully selected lens design further enhance its presence, and
the design specifies that it will not forget its sparkle even when it is not lit.

Can be customized according to installation

Since it is a one-unit type, you can customize it with your favorite combinations, and
just like the conventional 46LED product, you can also use only the inner lens.
In addition, it can be installed not only on large and medium-sized trucks, but also on specially equipped vehicles.

Heat compression bonding specifications

This product boasts extremely high quality because it is assembled using the same thermocompression method used to produce genuine domestic tail lamps.

Size

The size of this product is as follows.

Width 195mm x Height 213mm x Depth 80mm

This product has the same thermocompression bonding specifications as genuine domestic tail lenses . By using a thermocompression bonding method,
water leakage is prevented and the durability of the product is greatly improved.

*Guarantees other than the tail itself (business warranty, damage compensation, etc.) are not included.

Safety standard compliance

This product has been certified as a safety standard compliant product (E mark) .

What is a “safety standard compliant product (E mark)”?

A safety standard compliant product (E mark) is a certification based on global standards, and the safety standard compliant product (E mark) is engraved on the product itself. This is a global standard certification mark that is displayed on products that have obtained EC type certification, which certifies that they meet standards based on EU directives .
Even if they are repair parts such as after-sales parts made in Japan, the E mark is always displayed on parts sold all over the world.

*Depending on the number of installations, installation position, and installation method, the product may not pass vehicle inspection, so please check with the store/dealer where you purchased it or the installation factory.

Component part

The package contents of this product are as follows.

• Tail lamp body x 1 unit
• High flash prevention resistor x 1 (included only for turn signal type)
• Fixing bracket for mounting the main body Bolt and nut set *1
  • Bracket x 2
  • Nut x 2
  • Spring washer x 2
  • Flat washer x 2
• Stainless steel bolt set for connecting tail lamps
  • Bolt x 1
  • Nut x 1
  • Flat washer x 2
• For side mounting, for reflection × 1

*1 Regarding the connection bolt set, one set is included for each unit or two units purchased at the same time.

When purchasing 2 units of this product at the same time

If you purchase only one unit of this product, the connection harness (with high flash prevention/resistor) is not included.
If you purchase two units of this product at the same time, one connecting harness (with high flash prevention/resistor) will be included.
Please note that if you purchase two units of this product and install one on each side, a separate harness will be required.

Notes

Depending on the vehicle model, this product may have a bulb burnout warning light on. In that case, it can be canceled by installing a 4-wire resistor (sold separately).